followers 3 popularity
6
following 1

followers  view all

following  view all

Groups
racingnewss is not in any groups
racingnewss

BYD L3 small retrofit LED reading lights

May 15th 2015 at 12:19 AM

 

Modify your car you want? Do you want to expand your conversion Mind? Today group car network Xiaobian for you to explore new ideas, Con rod open your heart, only their own to create a model! We selected group car network of loyal friends and let him say a modified mentality!

I have ability in general, so the conversion process, often removed from the forum, also benefited. But I found that most of the technology is not enough clear description posted, that depends on a lot of patchwork postings to thoroughly understand a complete operating processes. Thus it found that many so-called technical stickers or not detailed enough, especially on some small details of the operation. We may have overestimated our ability to understand the riders and ability. So I uploaded a job, try to understand, the maximum extent so that the faithful car understand each step, convenient for everyone. But the level and energy is limited, if not understand also please forgive me!

Reading lights, a lot of high-end cars and in front of each one, usually only on the front, domestic small three is inventive, based on cost compromise on the middle, but the brightness is limited, just could not get around clear, and had surgery to give him a little move, transform the look!

Without further ado, began. From a treasure to buy lanterns, 24 groups, inexpensive, small twenty bar. Send two plugs, with three small we are headed to the left, the purpose is to achieve the effect of the original light two contacts, another single-head seems to be on top of the lamp driving position, leaving out the table.

Attached 3M adhesive on the back, in order to smooth some of their own cut from the middle down, leaving two line clearance to ensure that you can completely fit the top of the lamp. The fact that this step is very effective.

Next demolition reading lights, well demolished. First with a small screwdriver or a little rough nail near the rear cover from the lamp is inserted in the back of the two-gap, a little harder to pry it out of one down, from the figure we can clearly see the shade of two notches

Not a shade lamp, the middle of the bulb is the original car, the question will take it down. Prior to first put the lamp holder carries it to win, you can see the upper right and lower left of the two screws with crosswise you can easily win. Two clips a little tight, a little harder in order to remove the bulb. Get a head start from the best, do not force simultaneously. Started ringing off the hook to avoid injury.

Remove the bulbs, the LED lamps through the lamp socket, remember to wear the past, or have you regret later. Then on the card, the card is a little harder to cap both ends to the middle pressure look effortless. Powered try, a good light! Determine and correct the first fixed holder, 6 cylinder turbocharger and then the excess wire into the space inside the lamp on both sides, and then glue glue, then fasten the brightest shade better! White light!

0 comments
Please to comment

sign in

Username
Password
Remember Me


New to IM faceplate? join free!

Lost Password? click here