followers view all
|MclaurinWilliams is not in any groups|
Commercial Glass Installation For Yourself
It is completely possible for you to do commercial glass installation for yourself. Doing this job without hiring a professional will save you the money you would spend on a technician to do the work for you. You will not need a lot of expensive tools or equipment to do commercial glass installation for yourself.
You will need a pry bar and a measuring tape in order to do commercial glass installation of aluminum frame windows. Most of the commercial windows do have aluminum frames so these are the most common types of windows to be replaced.
The first step to commercial glass installation is to measure the dimensions of the window area to make certain you buy replacement pieces that will fit. Using the measuring tape you will measure the height of the frame. These measurements are taken from the sill to the underside of the jamb. The sill is the bottom framing board that sticks out slightly on the interior. The jamb will be the rest of the window framing. For this purpose you will measure to the jamb that is the uppermost piece. You will then measure the window from side jamb to side jamb. These measurements will be what you use to order your new replacement windows.
You will need to use the pry bar on the interior of the structure to pull the wooden stops that are on each side of the window. You will remove the sash by applying pressure from inside the windows frame and pressing firmly on the jamb liner. This should allow you to pull the sash forward from the top. Turn the sash slightly upward in order to break it free from the jamb liner.
Use a simple putty knife to scrape away any loose paint from the jambs. You will likely want to sand the jambs smooth and fill in any holes that are left from previous window installations. On the replacement window you will want to unscrew the access panel and remove the sash weights. Remove any fiberglass that might be in the weight pockets at this time.
The bottom portion of the window should be set in place first and then the top should be slowly moved into position. Once you have the window in place you will need to place screws in the pre-drilled holes of the aluminum frame.
Use caulk and expanding foam on the outside and inside of the window to fill in any gaps that are present. Expanding foam grows rapidly and will often grow out past the gap you were filling. Allow the foam to cure until it is firm and then you can trim the excess away. You will then replace any wooden sills or jamb pieces designed to be decorative.