followers 5 popularity
following 0

followers  view all

MclaurinWilliams is not in any groups

Aerospace Plastics For Aircraft Plastic Components

Dec 9th 2015 at 4:36 AM

Plastics cover a broad field of organic synthetic resin and may be divided into two main classifications - aerospace thermoplastics _ and aerospace thermosetting plastics. Thermoplastics may be softened by heat and can be dissolved in various organic solvents.

Aerospace Thermoplastics.

Thermoplastics may be softened by heat and can be dissolved in various organic solvents. Two kinds of transparent thermoplastic materials are commonly employed in windows, canopies, etc. These are known as acrylic plastics and cellulose acetate plastics. Cellulose acetate was used in the past but since it is dimensionally unstable and turns yellow after it has been installed for a time.

Aerospace Thermosetting Plastics.

Most of the moulded products of synthetic resin composition, such as phenolic, urea-formaldehyde, and melamine formaldehyde resins, belong to the thermosetting group. Once the plastic becomes hard, additional heat will not change it back into a liquid as it would with a thermoplastic.

Storage and handling.

Because transparent thermoplastic sheets soften and deform when they are heated, they must be where the temperature will never be excessive.

Aerospace thermoforming.

When they cool, they retain the shape to which they were formed. Acrylic plastic may be cold-bent into a single curvature if the material is thin and the bending radius is at least 180 times the thickness of the sheet. Cold bending beyond these limits will impose so much stress on the surface of the plastic that tiny fissures or cracks, called crazing, will form.

Forming methods.

Simple Curve Forming. Heat the plastic material to the recommended temperature, remove it from the heat source, and carefully drape it over the prepared form. Carefully press the hot plastic to the form and either hold or clamp the sheet in place until it cools. This process may take from ten minutes to one-half hour. Do not force-cool it.

Compound-Curve Forming.

Stretch forming. Preheated acrylic sheets are stretched mechanically over the form in much the same way as is done with the simple curved piece. Special care must be taken to preserve uniform thickness of the material, since some parts will have to stretch more than others.

For more information about Ptfe Sheet ,Peek Plastic,Delrin Acetal Plastic and Delrin Material please visit my website.

Please to comment

sign in

Remember Me

New to IM faceplate? join free!

Lost Password? click here